| Announcements : Removing D-Gun Valving Rod: Cleaning your Gusmer D-Gun Part 6 |
|
| on Monday, September 04, 2006 - 12:04 PM MST - 2364 Reads |
 |
Removing the D-Gun Valving Rod is a crucial step best accomplished with the air on and available to the trigger. If the rod is stuck a few good pushes on the rod assembly will extricate the stuck rod from the mixing module if lubricated liberally with glycolic either. DO NOT trigger unless you have the back of the valving rod covered.
|
|
|
| |
Rate article |
This article has not been rated
|
|
|
 |
|
